A-A-52193F
2.1 Design. The insulated food container shall consist of a sealed insulated plastic body and lid. Lids shall be interchangeable between sizes 1 and 2. The exterior of the food container shall have
an integral molded hand grasp handle which is continuous around the outside edge, and a minimum of four, over-the-center, plastic, lid locking latches. The food containers shall have the following maximum outside dimensions:
Width |
Length |
Height |
|
Size |
(inches) |
(inches) |
(inches) |
1 |
17 3/8 |
25 1/8 |
10 1/4 |
2 |
17 3/8 |
25 1/8 |
12 1/4 |
3 |
16 5/8 |
24 3/8 |
9 1/4 |
The food containers shall be stackable with an indentation in each outside corner of the lid to accommodate matching pads on the bottom of each container body. The stack ability interface shall be dimensionally the same for each size container. Size 1 and 2 containers shall be stackable when sizes are mixed in the same stack. The size 3 food container shall be nestable with a recessed bottom half of the body to accommodate matching insulated food containers. The nest ability interface shall be dimensionally the same for each size 3 container and shall reduce the stowage volume by more than or equal to 25% when two or more containers are nested together
as compared to being stacked.
2.1.1 Body. The insulated container body shall consist of an inner and outer shell made of high density plastic, which is NSF/ANSI Standard 2, and Food and Drug Administration (FDA) food grade approved; also insulated to comply with the temperature performance specified in 2.2. The interior shall accommodate one full size, or three, one-third size, steam table pans, 6 inches deep. The size 1 container interior shall accommodate three tray pack cans (see figure 1). The size 2 container interior shall accommodate four tray pack cans (see figure 1). The size 3 container interior shall accommodate five tray pack cans(see figure1). The body shall have a minimum of four plastic over-the-center latches. Latches shall be attached using stainless steel (American Iron and Steel Institute (AISI) types 304L or 316) machine screws threaded into the body. The latches shall be recessed from the outside edge of the body in both the latched and unlatched positions. Latches shall clamp the lid sufficiently to meet the thermal requirements specified in section 2.2.
2.1.2 Lid. The insulated lid shall be sealed, double walled, and made of high density plastic, which is Food and Drug Administration (FDA) food grade approved, and insulated to comply with the temperature performance specified in 2.2. The top surface of the lid shall have recessed
latching depressions to accommodate the latches installed on the body. The interior of the lid shall have special ribs to match the locations of the insert cover gaskets. When latched closed, the lid
shall compress the insert cover gasket to form a liquid-tight seal on each insert pan.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business