A-A-1080A
Military Standard:
MIL-STD-105- Sampling Procedures and Tables for Inspection by Attributes.
Copies of military standards may be obtained from Standardization Documents Order Desk, Bldg, 700 Robbins Avenue, Philadelphia, PA 19111-5094.
ASTM Standard:
E 29- Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specification.
Application for copies of ASTM standards should be addressed to ASTM, 1916 Race Street, Philadelphia, PA 19103.
3. SALIENT CHARACTERISTICS
3.1 Design and construction. The can opener shall be constructed from nickel-plated carbon steel. One end of the opener shall have a bottle opener capable of opening a compression type bottle cap. The other end of the opener shall be of a triangular punch design capable of punching a V-shaped opening 11/16 inch (17.5 mm) in width in the tops of steel cans. The end with the bottle opener shall have a 3/16 inch (4.8 mm) minimum hole for hanging purposes.
3.2 Dimensions. The can opener shall have an overall length of 4-1/4 inches (10.8 cm), + 1/4 inch (0.6 cm). The can opener shall have a minimum width of 23/32 inch (1.8 cm) at the narrowest section and a minimum thickness of 0.055 inch (1.4 mm).
3.3 Finish. The can opener shall have a bright nickel-plated finish.
3.4 Workmanship. The opener shall be free from sharp edges (except for the punch opener end), slivers, burrs, deep scratches, pits, and tool marks. The opener shall not be bent, damaged, or distorted. Surfaces shall be free of loose or flaked plating. There shall be no defects which impair the durability, appearance, or serviceability of the item.
3.5 Regulatory requirements. The offeror/contractor is encouraged to use recovered materials in accordance with Public Law 94-580, as amended, to the maximum extent practicable.
3.6 Measurement system. The values stated in inch-pound units are to be regarded as the standard. The values stated in parentheses are for informational purposes only.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business